Getting Started on Choosing Your AGR System…
HOW TO GET STARTED
It’s important to remember when installing a generator, that it’s not really for the average DIY enthusiast. Your generator connects to your home’s electrical panel and either natural gas or propane, which should be installed by an experienced professional.
As a result, installing your generator starts with a site visit or virtual inspection by your local AGR Dealer or licensed professional. They will assist you in selecting the appropriate generator size, the optimal fuel source, the ideal location for your generator/cover and placement of your power inlet box. They will then take a look at your breaker box and determine the correct interlock switch or manual transfer switch needed for your home.
GETTING STARTED
Step 1
Select the right size Duromax generator for your power needs (10,000-15,000 watt, Duel or Tri-Fuel)Step 2
Select the correct GENSTART soft starter units (based on FLA and LRA located on your condenser’s data plate) needed for wiring up to your HVAC condenser(s). Count the number of HVAC condensers for your home and check to make sure they are non-variable speed units. Then select the number GENSTARTS needed.Step 3
Select the right size Power Cord (30 or 50 amp).Step 4
Select the right size Reliance Power Inlet Box (30 or 50 amp) or Manual Transfer Switch (30 or 50 amp). If you chose a Manual Transfer Switch, then skip Step 5 below.Step 5
Select the correct InterLock Switch for your electrical panel by choosing 100, 150 or 200 amp service coming into your home and the correct Manufacturer brand of the panel.Step 6
Select the CITADEL cover and Pad for your Duromax generator for a stylish look, protection against the elements and noise reduction.Step 7
Lastly, complete your purchase and hire a licensed professional to install your AGR system.
